Comments on: Assembling the MakerBot CupCake Extruder http://www.neufeld.newton.ks.us/electronics/?p=555 Sun, 08 Dec 2024 17:19:24 -0600 hourly 1 http://wordpress.org/?v=3.1.3 By: Keith Neufeld http://www.neufeld.newton.ks.us/electronics/?p=555&cpage=1#comment-23212 Keith Neufeld Wed, 20 May 2009 15:55:40 +0000 http://www.neufeld.newton.ks.us/electronics/?p=555#comment-23212 Gav, thanks for the note! I'll double-check the idler wheel spacing before I get going. Gav, thanks for the note! I’ll double-check the idler wheel spacing before I get going.

]]> By: Gav http://www.neufeld.newton.ks.us/electronics/?p=555&cpage=1#comment-23205 Gav Tue, 19 May 2009 21:38:57 +0000 http://www.neufeld.newton.ks.us/electronics/?p=555#comment-23205 Nice writeup Keith, and some good quality pictures. Watch out for the width of the idler pulley slot though. The lasercutting is a little conservative, myself and a few others have had to file more away to get the extruder to work reliably. Nice writeup Keith, and some good quality pictures.

Watch out for the width of the idler pulley slot though. The lasercutting is a little conservative, myself and a few others have had to file more away to get the extruder to work reliably.

]]>