«
»

Voron 2.4 Build — DIN Rail Slots

Underside of Voron 2.4 printer with DIN rails

No amount of optimism will make the M5 machine screws fit into the slots in the DIN rails. The earlier one files that out, the better.

This entry was posted on Sunday, November 21st, 2021 at 07:44 pm by Keith Neufeld and is filed under 3D Printing, Voron. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

Leave a Reply